ElecGear 4pcs EL3 Replacement Joystick Additional Gift Drift Correction Variable ALPS 10K Analog Stick Controller Sensor Thumbstick Module Repair Part

【EL3 for Switch Pro】 – 4 replacement analog joysticks work with Switch Pro and some PS3 controllers. The thumbstick module is made by ALPS. This RKJXV stick controller series comes with a 10K ohm trimmer potentiometer (🔺See B0CYBLZPW1 for Hall effect version.) 【Compatibility】 – This version of the analog joystick comes with a dark gray bottom plate with two plastic sticks inserted into the PCB. Locks in 3 directions when not attached to the controller cover. Potentiometer sensor can be green or black. It was used with the Switch Pro controller. It is also found on some PS3 controllers. There were also reports that it was also used in the 8Bitdo SNES controller. [Additional Gift Drift Fix PCB] – Joystick drift is a common problem. Even new joysticks can drift. Potentiometers were born without precision. It was not centered due to carbon film wear, spring fatigue, and material stretching. Dust, moisture, and drops make it worse. We packed the PCB as a gift to solve the problem of drifting in one direction. Drift can be eliminated by simply adjusting the variable resistor 【Time to Replace】 – You need to replace your analog joystick if your controller has problems with drifting, creeping, stuttering, blind spots, dead spots, dead zones, no response on clicks, or not being centered after many years. wear and tear. OEM genuine repair parts ensure accuracy and extend lifespan [DIY Reminder] – There are 14 prongs, so soldering and soldering the entire module requires considerable skill. To resolve most joystick issues, we recommend replacing the potentiometer first. There are two recommended methods for removing the entire joystick module from the PCB. 1. See Desoldering Kit with Product ID: B0BK7169M8. 2. Alternatively, you can use wire cutters to cut each of the 14 prongs one by one. Please go to B0CYBLZPW1 for the Hall Effect Joystick for Switch Pro Please take a look at product ID: B0BK7169M8 for the desoldering kit EL3 for Switch Pro and some PS3 controllers 4x replacement analog joystick work with Nintendo Switch Pro and some PS3 controllers. The thumbstick module was made by ALPS. This RKJXV stick controller series comes with 10KΩ trimmer potentiometers. The analog stick comes in dark gray bottom plate with two plastic sticks inserting in the PCB . It locks in 3 directions when not sit in controller cover. The trim pot resistors can be in green or black. It is widely used in Switch Pro controller. Some reported it is also used in 8Bitdo SNES contro llers ✔ Replace the wiper alone even without soldering In some cases, you can just replace the wheel in the potentiometer to solve specific problems like: Stuttering, dead zone, creeping, or not as responsive as it should be ✔ Replace the potentiometer alone with an iron 80% chances of joystick problem are caused by the sensor. In another words, the rotary mechanism and the tactile switches are not the problem. De-soldering the unit with only 3Pin can be easier than replacing the entire module with as many as 14 prongs ✔ A heat gun to replace the whole module This is the most suggested for an experienced soldering expert ✔ Experts with a normal iron to replace the whole unit For a soldering expert with no professional de-soldering wick braid, solder sucker pump or hot air rework station at hand. To make it easy, we suggest crushing the problem joystick into small enough pieces with a pair of pliers ✔ By professional technicians in a cellphone repair shop Suggested for someone with no handy tools