Made of high‑quality materials, waterproof and dustproof, for has a service life.
Specially designed for remote control car with excellent starting, acceleration and linear characteristics.
Compatible for 1Celsius10 1Celsius8 RC car electric speed controller with XT60 plug, fit well.
Item Type: Electric Speed Controller
Material: Plastic+Alloy
Color: Red Black
Size: Approx. 60x45x45mmCelsius2.4x1.8x1.8in
Weight: Approx. 201.0gCelsius7.1oz
Continuous Current: 120A
Maximum Current: 600A
Motor Type: Sensorless and Brushless Motor
For 4S or 12 nimh cells:
1. On-road: 40xx size or smaller engine, 2. Off-roadCelsiusoff-road vehicleCelsiusfor : 40xx size or smaller engine with kv For 6s or 18 nimh cells:
1.On-road: 40xx size or smaller engine with kv 2. Off-roadCelsiusoff-road vehicleCelsiusfor : 40xx size or smaller engine with kv Resistance: 0.00035ohm
Battery: 3-6 Cells Celsius 9-18 Cells NIMH
Bec Output: 6.1VCelsius3A ( Mode)
Fitment:
Fit for 1Celsius10 RC Cars
Fit for 1Celsius8 RC Cars
Instuction:
1. Connect BEC wires with the receive
2. Connect motor wires with ESC
3. Turn on the transmitter
4. Connect battery pack with ESC then on the ESC
5. When the connection of motor and battery is finished, the motor emits beep-beep .
6. When the throttle stick is In the neutral position, the motor re-emits beep-beep
7. The ESC is workable
8. 120A BEC voltage change: turn off ESC, connect the short circuit chip to bec, turn on ESC, and the motor will emit beep . After 2 seconds, pull out the short circuit chip to the BEC. When the change of BEC voltage is completed, the motor beeps - beep (if be (the voltage is 6.1v, the motor beeps). If be (7.3v motor beeps twice), turn off BEC voltage change.
Troubleshooting:
1 . If after power on , motor can , t work , no sound is emitted-please check the connections between battery pack and motor .
2 . If after power on , LED flashes , please check the voltage of battery pack , which should be from ;5V-25.5V:
3 . If the motor emits a beep-beep Only ( BEC voltage 6.1V ) or If the motor emits a beep-beep twice ( BEC voltage 7.3V ) , please check all the connections : BEC wires , transmitter andreceiver , throttle signal wires , etc . please check the transmitter TH . TRIM and adjust it to the motor re-emits Beep-beep
4 . If the car can t be speed up , please check either voltage of the battery pack is too low or the temperature of ESC is too high . If the voltage of the battery pack is too low , please replace the battery pack . If the temperature of ESC is too high , please check all connections . If not , please push the button EPA on your remote control
5 . If the car stops suddenly while in working state , please check the motor s connections , and the road
6 . If the car runs in the opposite direction , which the transmitter is available , please swap two wire connections between the ESC and the motor