12V Electric Oil Pump Extractor, Automotive Transfer, Extraction with 5L mum Rate for Quick Cleaning Changes, Industrial Equipment

Widely used in general industrial equipment Maximum pressure: Maximum 0.8MPA An ideal equipment for quick and clean oil‑changes Description: This oil extractor transfer pump uses 12v self-priming pump to exchange car engine oil. It works by connecting the clamps to the 12V car-battery,and widely used in general industrial equipment, cause this pump can pump oil not only, also can pump hydraulic oil and other liquid. It is an ideal equipment for quick and clean oil-changes. Features: 1. Widely used in general industrial equipment. 2. It works by connecting the clamps to the 12V car-battery. 3. An ideal equipment for quick and clean oil-changes. 4. Connect the car battery to start, power off, easy to use. Specifications: Rated Voltage: 12V Rated Power: 60W Maximum Pressure: Maximum 0.8MPA Maximum : 5LCelsiusmin Pump Diameter: Approx. 4.8cm Celsius 1.89 Length: Approx. 14.5cm Celsius 5.7 Outlet Pipe Size(Dia.x L): Approx. 11mm x 140cm Celsius 0.43 x 55 Inlet Pipe Diameter: Approx. 8mm & 6 mm Celsius 0.31 & 0.24 Inlet Pipe Length: Approx. 100cm Celsius 39.37 Cable Length: Approx. 30cm Celsius 11.8 Clips Length: Approx. 8cm Celsius 3.15 Main Color: Black Application: Widely used in general industrial equipment, chemical equipment, shipbuilding, drinks, carpet and floor cleaning, water purification and water treatment equipment, vehicle cleaning, agricultural spraying, zo pipeline pressure, cleaning cooling, coal and metallurgical industries How to use: 1. Start to run the car engine for a while, when oil temperature turns to be about 50 degrees, start pumping oil. 2. Connect the pump to the power, run it for a while, and observe whether the inlet and outlet is normal. 3. Open the filler ,get dipstick out, force the tube into the bottom of the joint, until the tube does not move; then put the inlet pipe from the oil dipstick into in end (the tube into the bottom of the , the bottom concave place, in order to pump the oil completely); as no oil or pumping up very slowly or intermittently, it is generally caused by loose pipes and fittings. You have to install the pipes and fittings again.) 4. After oil pumping, remove the tube, and then run the pump for a while, pump the remaining oil inside the pumping clean, or pump water for a while until the pump head gets clean. 5. If you have not used it for a time, it may have no suction, then just pour the water in the pump, and run the pump for a few minutes until the is all out. Package Inculded: 1 x oil pump 1 x 11mm outlet pipe 1 x 8mm inlet pipe 1 x 6mm inlet pipe 2 x clips Note: 1. Please allow 1-3mm error due to manual measurement. Thanks for your understanding. 2. If you want to connect this pump to AC power, you will need a power converter. 3. Please use when the engine is warm, the engine oil is warm and viscosity is lower, this will be easier and to pump. 4. This product is not allowed to pump corrosive liquids, strong acids and strong alkaline liquids. 5.