Wind Direction Sensor,Accuracy Three Cups Cable Wind Measurement Anemometer Sensor Replacement for Outdoor Use

CHARACTERISTICS: Wind direction sensor is characterized by good linearity, high accuracy, no dead spot, no fear of strike, and easy observation, more stable and use. Users can know the wind direction through the sensor and make corresponding decisions and countermeasures. ALL AROUND: The internal angle sensor is able to realize all round 360 degrees wind direction monitoring. Users can get a full range of wind direction information, ensuring the comprehensiveness and accuracy of the data. PREMIUM MATERIAL: Made of low inertia ABS material with good dynamic characteristics. The premium material made it has stable performance and lasting reliability, and well in various environments. Item Type: Wind Direction Sensor Material: ABS Weight: Approx. 385g Celsius 13.6oz Product Size: Approx. 223x190x70mm Celsius 8.8x7.5x2.8in Supply Voltage: 9-30V Output: 4-20mA Extension Wire Length At Connection: 0.8m Celsius 2.6ft Accuracy: Directional: +Celsius- 3 degrees Resolution: Directional: 1 degrees Starting Wind Speed: less than 0.8mCelsiuss Maximum Power Consumption: 0.48W Load Capacity: 12V power supply, current type output impedance less than 350 Ohm , 24V power supply, current type output impedance less than 900 Ohm , voltage type output impedance more than 1K Ohm Operating Environment: Temperature -35 celsius -60 celsius Humidity: less than 100% without condensation Prevention Grade: IP64 Cable Grade: Rated Voltage: 300V 80 degrees C Mounting Hole Diameter: 3.2mm Celsius 0.13in Aerial Plug Diameter: 15mm Celsius 0.59in (It is recommended to reserve 25mm Celsius 0.98in for easy wiring, wiring first, then install the fixed sensor) Calculation : 4-20mA: F=(I-4)Celsius16x359 Attention: F: Indicates the wind direction angle value, unit: degrees . I: Sensor output current value, mA Wiring Methods (Wire )  Wire color  Output signal (current)

Red Power

Black Power negative

Yellow Signal Troubleshooting : 1. The wind blades do not rotate properly, and the hysteresis is big. There are foreign objects or jammed in the bearing due to term use. Please send the sensor back to the company for processing. 2. Analog signal meter display value is not correct. Possible wiring problems or communication serial port failure caused by the inability to obtain the correct data. Please check whether the wiring is correct and firm, whether the serial port is occupied, and whether the serial port setting is correct. 3. If it is not the reasons, please contact customer service.