27W LED Spot Light 12pcs 5W LED Bulbs Searchlight with Remote Control Rotatable IP65 Water Proof for Boat Outdoor SUV Truck Ship

LED Searchlight: The spot light is composed of 12pcs 5W super bright LED bulb. It is very and energy saving. The lighting can get up to 200 feet. The lamp operates on 12V or 24V circuits and is equipped with overload, overheat and overspeed . Multi Functions: The spot light can be rotated and tilted through the wireless remote control. With flashing and SOS mode, automatic search function and reset function. Bright Lighting: Can clearly illuminate the search target and is very suitable for working at night. Equipped with wireless remote control, the remote control is very sensitive and can be controlled wirelessly within 30m. Item Type: LED Searchlight Model: E016001 B Material: PC, acrylic, PA.

: Remote Control Beam Angle: 6 +Celsius- 2 degrees Rotation: 340 degrees Elevating: 22 degrees up, 48 degrees down. Rotation Speed: 8-10 degrees per second under 12V , 12-14 degrees per second under 24V . Lifting Speed: 11-14 degrees per second under 12V , 19-21 degrees per second under 24V . Power Cord Length: Approx. Celsius 13.12ft Power Consumption: 27W LED: 12pcs 5W Working Voltage: 12V 2.2A or 24V 1.1A. LED Color and Color Temperature: Sunlight white, 5500-6300K. LED Beam Angle and Luminous Flux: 120 degrees , 160-190lm. Effective Luminous Flux and Power: 1600lm, 200W. Sensing Distance: Approx. 30m Celsius 98.43ft. Remote Control Frequency: 433 MHz Working Temperature: -20 celsius . +45 celsius . 1000 Hours LED Lamp Life Test: The luminous flux maintenance rate > 90%. Waterproof Standard: IP65 Remote Control Battery: 2 X 1.5V , shipped without battery. A. Installation Instructions: 1. The searchlight must be installed on a flat and for optimal use. Keep the light far away from the sail, cable or other positions that may cause damage to the light. You need to access the lower side of the selected location and drill at the location. Make sure there are no wires or other structures where the screws need to be drilled. 2. In order to minimize glaring, it is best to install the lights as far ahead as possible and as high as possible. 3. The four base mounting holes and the central harness holes on the mounting of the washer must be adopted in accordance with the user manual. 4. Drill four 1Celsius8in holes at the marked points. 5. Please place the white circular mounting washer on the base of the lamp and that the harness passes through the central hole of the washer. 6. Pass the wire from the lamp base through the center hole of the mounting . Sealant can be applied around the hole and the harness through the installation . 7. Wire Connection: The red cable must be connected to the red wire of the searchlight, and the black cable must be connected to the black wire of the searchlight. 8. Fix the lamp on the mounting with the lens facing forward. Align the four holes on the lamp holder and mounting gasket with the four corner holes drilled into the mounting . 9. Use four M5 self tapping screws to firmly fix the searchlight. Do not overtighten. B. Initial Remote Control Programming: 1. Press and hold the PA button on the remote control. 2. When pressing the button, connect the red wire to the terminal and the black wire to the negative terminal. 3. After 10 seconds, release the button pressed. When the button is released, the remote control will be programmed. 4. The remote control will be al. 5. To clear the previous pairing with the remote control, press and hold the CL button, then turn on the power of the light until it flashes once, and then release the CL button. Re pairing the remote control will all normal .