Product Specifications: Name: Frosted Glass Flower Pattern Privacy, Heat Insulation, and UV Cut Glass Film; Dimensions: 90cm (width) x 200cm (length); Material: PVC, PET.
*Package Contents
1 window film (color: flower, 90cm width, 200cm length), 1 instruction manual.
*Precautions for Use
Before applying to the window glass, be sure to remove the protective transparent sheet. (If the release film is not removed, it may fall off the window glass immediately.)
Be careful not to apply it inside out. The side that contacts the release film is the back of the main body, and this is the side that is applied to the window glass. This is an indoor application type. Applying it from the outside will significantly reduce its lifespan. Always apply from the inside to a smooth (non-bumpy) glass surface.
※Product Description
Made from high-quality PET material imported from Europe and America, which is healthy and environmentally friendly, and is also thick, so it has a longer lifespan than general commercially available window films.
★Applicable glass:
Applicable to all smooth surface (no bumps) glass.
This product is not suitable for rough surfaces such as wood, tiles, or frosted glass, or for porous glass surfaces.
Even with structures like double-glazed (double-pane) and wired glass, as long as the surface is flat (smooth), it can be applied neatly, so please rest assured.
However, in areas that receive a lot of direct sunlight for many years (such as equatorial regions), applying a film with a high heat absorption rate to wired glass, double-glazed (double-pane) glass may cause thermal cracking.
★How to apply:
1. First, measure the length and width of the window glass. Measure from inside the rubber gasket on the inside of the sash.
2. Add a 20mm allowance to the measured window glass size and cut. When marking, be sure to mark the back side.
3. Attach cellophane tape to the corners of the release film and the glass film, and peel off the release film from the glass film. 4. Slowly peel off the release film, and spray plenty of water onto the adhesive side of the film. 5. Spray plenty of water onto the window. 6. Stretch the film parallel to the window and stick it to the glass surface.7. Spray water onto the applied film again. 8. Using a plastic spatula (a ruler is also OK), push out any air or water trapped between the glass surface and the film, working from the center outwards. 9. Once all the air and water inside the glass film has been pushed out and it is firmly attached, place a spatula on the trim and cut with a cutter. To prevent peeling, it is recommended to cut it 2mm smaller than the rubber gasket on the inside of the window frame. 10. Finally, wipe away any moisture from the window frame and floor, and you're done.
Товар из Японии 
Возврат по недоставке
