DC-DC15A 300W Boost Converter Module 5-24V to 15V 20V 24V 30V Fixed Output 95% High Efficiency Overheat Overvoltage Protection

PCBincluded : Yes Voltage range : USB (5-20V DC) Output Power : ＜18.65 Use : others Item Type : Power Supply Electronic : no Charger included : N Battery Included : no High-concerned chemical : none Model Number : DC-DC 15A 300W High-Power Boost Module Accessory Type : Charger Accessories Brand Name : occkic Origin : Mainland China Certification : NONE

Features 1. Supports 5–24V input; output voltage (15V, 20V, 24V, or 30V) can be switched via a jumper setting 2. Conversion efficiency exceeds 95%; features robust heat dissipation and remains cool even during prolonged full-load operation 3. The module includes over-temperature protection and delivers robust performance to meet high-power boost requirements 4. Utilizes high-frequency capacitors, high-efficiency control chips, and high-current MOSFETs for stable performance 5. Built-in overvoltage and over-temperature protection, with TVS diodes on both input and output for safety and reliability Product Introduction This product is a high-performance, high-power-density boost module. It utilizes a high-efficiency control chip and high-current MOSFETs, combined with high-quality ECP inductors, enabling the module to continuously deliver 300W of power at a 24V input and 30V output. Equipped with over-temperature protection, it delivers robust performance and meets high-power boost requirements. Suitable for various fields such as automotive electronics, industrial control, and communications equipment Parameter Input Voltage: DC 5–24V (must be lower than the output voltage) Input Current: 15A Output Voltage: 15V, 20V, 24V, 30V (default 15V; other voltages selected by shorting pins) Output Power: 300W Quiescent Current: 3mA Module Pins VIN+: DC input positive terminal GND: DC input negative terminal, connected to the output negative terminal OUT+: DC output positive terminal EN: Boost enable pin; boost is enabled by default; connect to GND to disable boost (only disables boost) By default, the EN pin requires no connection. To disable boost, simply pull the EN voltage down to 0V. Note that in this state, boost is disabled but an output voltage remains, approximately equal to the input voltage. Package include Boost module × 1

label:yes