LiNKFOR Speaker Selector with Spring Clip 1 Passive No Power Supply Independent Area for Speaker Bare Wire Only 2-Zone Terminals, Input/2 Output,

[Speaker Selector with Free Control over 2 Areas in One Amplifier] With two independent buttons on the front panel, you can output sound from only Area A, only Area B, or both areas simultaneously. Enjoy flexible music playback in a variety of spaces, such as living rooms, studies, shops, and offices. [Passive Design, Plug & Play] The passive design eliminates the need for a power supply, preventing power supply noise. It transmits the signal directly from the amplifier, resulting in clear, low-distortion sound quality. [Maximum 150W support & compatible with a wide range of speakers from 4Ω to 16Ω] Each channel supports up to 150W (RMS), allowing the use of a wide range of passive speakers from 4Ω to 16Ω. It is compatible with home theater systems and ceiling-mounted speakers (volume is adjusted on the amplifier side). [Stable, high-quality sound even with long-distance wiring up to 50m] Speaker cables can be extended up to 50m, even in large spaces such as cafes and offices. High-quality internal design minimizes signal attenuation, maintaining clear sound quality even over long distances. 【Stable Design & Bare Wire Terminals】Non-slip pads on all four corners of the base ensure stable placement even on AV racks. The spring-type spring clip terminals are designed exclusively for bare wires (with insulation stripped), making wiring easy even for beginners. Banana plugs and pin terminals are not supported. [Easy Connection for Low-Cost Multi-Room Audio System Setup] This single unit allows for sound management of multiple areas without the need for expensive multi-zone amplifiers. It features spring-loaded clip terminals, allowing for easy connection by simply inserting bare wires. You can build a distributed audio system in a short amount of time.