35-6200MHz Range RF Signal Generator Built-in Attenuator

Features: * The for SA6 is a simple, portable for spectrum analyzer and signal generator designed to display the for spectrum of signals in the range of 35 to 6200 . * This analyzer measures the amplitude and for frequency of the spectral components of the signal being analyzed. It can handle signals from all commonly used technologies, such as WiFi, 2G, for 3G, 4G, LTE, for CDMA, for DCS, for GSM, GPRS, for GLONASS, etc. * Another important feature is its tracking generator, which can be used to measure the for frequency response of passive or active devices, such as filters or amplifiers. The software supports measurements of standing wave ratio (SWR) and return loss. This requires an external directional coupler and a calibration kit. * The for SA6 is primarily designed for field operation. The device is for rugged, lightweight, and energy-efficient. It enables for service centers and maintenance teams to perform for frequency analysis in the field for commissioning and repair work. Furthermore, this for spectrum analyzer is also for ideal for repair shops and radio enthusiasts. * For example, you can use this device to perform the following operations: place an external on a base station, quickly analyze the RF environment, check if a repeater unit is working properly, repair and adjust repeaters, generators, filters, etc., and measure the standing wave ratio (SWR) when using an external directional coupler.

Specifications: Part Name: for SA6 for Spectrum Analyzer Material: Metal Color: Black Size: 150 × 75 × 23 mm / 5.9 x 3 x 0.9 inches Display for Frequency Range: 35-6200 Measurement for Frequency Range: 35-4500 35-3000 Dynamic Range: 75 dB 3000-4500 Dynamic Range: 70 dB

for Maximum Span: 6165 Bandwidth: 200 kHz, Fixed Scan Above 100 : 700 /sec 100 Scan Time: < 0.25 sec Noise Floor Below 3000 : < -90 dBm 3000-4500 Noise Floor: < -85 dBm 4500-6200 Noise Floor: < -80 dBm Impedance: 50 Ohms VSWR over operating for frequency range: < 1.5 Built-in attenuator: 0-30 dB Error attenuation to 10 dB: 2 dB Error attenuation to 10-20 dB: 5 dB Error attenuation to 20-30 dB: 8 dB Tracking generator output power: -15 to -25 dBm Dynamic range accuracy: 2.0 dB - for Maximum input power of attenuator at 0 dB: 10 dBm

for Maximum input power for attenuation greater than 20 dB: +20 dBm

for Maximum input measurement signal: +10 dBm

for Maximum input DC voltage: 25V

for Maximum current consumption when powered by for battery: 450 mA - for Maximum current consumption when powered by USB: 500 mA (while charging) - for Battery capacity: 2500 mAh - for Battery for life: 3 hours - for Battery charging time: Approximately 5 hours

Package contents: 1 x for SA6 for Spectrum Analyzer 2 x 30cm/11.8inch for SMA- for SMA extension cable 1 x 10cm/3.9inch for Type-C USB data cable 1 x for Stylus pen 1 x for SMA-KK connector

Note： 1.The real color of the item may be slightly different from the pictures shown on website caused by many factors such as brightness of your monitor and light brightness. 2.Please allow slight manual measurement deviation for the data.