SOLAR BATTERY CHARGE CONTROLLER SCC-60A-PWM-LCD-S2
Photovoltaic panels are a clean and ecological source of electricity. Obtaining this energy, however, poses a number of challenges for device designers. The amount of energy produced by the panel strongly depends on the angle of incidence and the intensity of light falling on the cell surface.
This, in turn, leads to unstable power output parameters, as even shading a small section of the panel can drastically reduce efficiency. The optimal solution to the problems mentioned above is to use a set consisting of a photovoltaic panel, a battery, and a charge controller.
This set allows for consistent power supply parameters for loads and also stores excess energy for later use. The SCC-60A-PWM-LCD-S2 solar controller allows for the connection of panels connected in both series and parallel – while ensuring that the permissible current and voltage values at the device's input are not exceeded.
Due to the operating characteristics of PWM controllers, it is important to remember that when panels are connected in series, the nominal output voltage intended for battery charging is 24V. Note: Solar controllers are designed to work with photovoltaic panels.
They should not be used with other power sources.
• Regulation type: PWM
• Nominal voltage: 12 / 24 V
• Nominal current: 60 A
• Permissible voltage range: ≤ 25 V for a 12 V battery - The range of the highest operating voltage of a set of panels connected to one controller input, ≤ 50 V for a 24 V battery - The range of the highest operating voltage of the set panels connected to one regulator input
• Battery charging voltage: 13 V ... 15 V (adjustable)
• Output voltage: Equal to the voltage at the battery terminals
• Battery charging current: max. 60 A
• Load current: max. 20 A
• Weight: 0.28 kg
• Dimensions: 182 x 90 x 46 mm
• Warranty: 2 years
• 2 x USB power output: 5 V / 2 A,
24H - the load is powered all the time, 1H ... 23H - the load is powered for a selected number of hours after sunset, 0H - the load is powered from dusk to dawn 2 x USB power output: 5 V / 2 A, Load disconnection voltage (protection against excessive battery discharge): 9 ...
11.5 V (adjustable), The device is designed to charge only rechargeable batteries AGM, gel and lead-acid batteries, LCD display, LEDs indicating the device's operating status, Operating modes: 24H - the load is powered all the time 1H ...
23H - the load is powered for a selected number of hours after sunset 0H - the load is powered from dusk to dawn