CV Joint Axle Boot Repair Kit 2PCS Drive Shaft Dust Cover Set with Expander Tool for DIY Car Enthusiasts

# 2PCS Universal CV Joint Boot Repair Kit with Manual Expander This is your cost-effective go-to solution for CV joint dust cover replacement, suitable for both professional mechanics and car owners who prefer DIY maintenance!

### Product Features #### Sturdy & Long-Lasting This CV axle boot set is constructed with thickened high-elastic neoprene rubber, paired with rust-resistant stainless steel clamps, delivering outstanding abrasion and aging resistance. It retains perfect elasticity and structural stability even in high-temperature, muddy or dusty working environments, and will not deform easily for long-lasting performance. #### Perfect Size Fit Each boot is 5.5 inches (13.9cm) in length, with a 0.78 inch (1.9cm) inner diameter for the top opening, fits most CV joints with 0.78-0.98 inch (1.9-2.4cm) caliber. Do verify your joint size before purchase to get a perfect fit. #### Reliable Protection Once installed properly, the boot seals tightly to the inner (gearbox side) or outer (wheel side) CV joint on your drive axle, effectively stops dust, water, mud and small debris from getting into the ball cage, cuts down wear and greatly prolongs the service life of your CV joint, saving you hundreds of dollars on professional repair costs. #### Easy to Install Installation is a breeze. The kit comes with a dedicated manual expander: just flip the boot, insert it into the expander, align with the gimbal position, push the boot to cover the gimbal completely, then secure the openings with the included clamps. No extra complex tools needed. #### Wide Application This repair kit works perfectly for most passenger cars, trucks, SUVs and other common vehicles, meets all your CV joint dust cover replacement needs.

### Full Package (13 Pieces Total) 2 × Thickened rubber dust covers, 4 × Stainless steel clamps, 6 ×, 1 × Manual expander.

### Installation Tips First take off the old dust cover and clean the CV joint and axle thoroughly. Apply sufficient grease to both inner and outer sides of the new boot, expand its small end with the included spreader, slide it onto the axle to fit the CV joint, take off the spreader, add required grease, then tighten both ends with the clamps to finish. The merchant warrants that their products comply with all applicable laws, and are offered only if they comply with Joom's policies and EU Product Safety and Compliance laws.