KL-200NP Facade plug with driven-in plastic pin!!!
Driven-in facade plug with plastic pin for deep installation in thermal insulation with thermal insulation plug.
Package 250 pcs.
Size: Ø10
Product: KL-200NP
Connector diameter [d]: 10 mm
Connector length [L1]: 200 mm
Plate diameter [D]: 60 mm
Approvals
ETA-07/0291
AT-15-8091/2015
AT-15-9119/2015
Features and benefits
Installation in all substrates (categories A, B, C, D, E).
The product is recommended for deep installation in thermal insulation (with a thermal insulation plug), reduces thermal transmittance and guarantees a homogeneous facade surface.
The precise design of the plug allows for achieving the best parameters using an anchoring zone reduced to 25 mm.
The high stiffness of the plate (0.4 kN/mm) ensures the stability of the thermal insulation system, counteracting vibrations caused by wind suction forces.
The product provides the necessary technical parameters at a low cost.
Can be installed with an additional KWL plate available in diameters of 90, 110, 140 mm.
Applications
Facade insulation systems
(etics)
Styrofoam boards
Mineral wool boards
Wood wool boards
Polyurethane boards
Lightweight thermal insulation boards
Substrate material
Certified for:
Concrete C20/25-C50/60
Solid brick
Channel concrete slab
Solid silicate brick
Hollow silicate brick
Lightweight concrete blocks
Lightweight concrete hollow block
Lightweight concrete components
Aerated concrete
Installation instructions
1. Drill a hole of the appropriate diameter and depth.
2. By striking Lightly tap the expansion plug sleeve with a hammer until it is completely embedded in the thermal insulation (the plug plate should be level with the thermal insulation).
3. Drive in the steel pin until the plug is completely anchored and level with the thermal insulation surface.
4. The anchoring depth for substrates of category A, B, C (concrete, solid and perforated bricks) is 25mm, for substrate D (lightweight concrete blocks) 40mm, for substrate E (aerated concrete) 60mm.
5. To achieve a deep installation of the plug in the thermal insulation, cut a hole in the thermal insulation using a KFS cutter, then after installing the connector, close the hole with a plug appropriate for the type of thermal insulation (KES - polystyrene / KES-MW mineral wool).
6. For the installation of soft thermal insulation and lamella wool, it is recommended to use a plug with an additional KWL pressure plate with a diameter of 90, 110 or 140 mm.