• Tuningfan shift pattern emblem for 7MT cars
• Base hairline + clear dome processing Size: Height 16mm Width 22mm Thickness approx. 2mm
• Uses non-yellowing polyurethane resin Adhesive: Strong adhesive Made in Japan
Shift pattern emblem for rare 7MT cars!
Isuzu Giga Fuso Super Great Hino Dolphin Profia UD Big Sam Quon
Recommended for etc.
Dome processing using highly transparent polyurethane resin
Achieves both three-dimensional and beautiful gloss and high durability due to UV protection
Upgrade your interior with a luxurious feel that is different from ordinary stickers!
Compatible with all 7-speed manual cars with the same marking pattern.
It can be installed by simply pasting it on the side of the shift boot or on the shift panel.
Size: Height 16mm Width 22mm Thickness approx. 2mm
The dimensions are approximately the same as the genuine shift pattern label from the car manufacturer so that it can be applied anywhere.
A simple and timeless design that eliminates unnecessary logos and decorations.
*A shift knob without a shift pattern written on it will not pass vehicle inspection.
When driving on public roads, it is mandatory to install such a shift pattern plate.
Recommended for those who do not have a pattern plate installed with an aftermarket shift knob.
The adhesive for this product is made of the strongest adhesive material,
If there is dust or oil on the adhesive surface, the adhesive strength will be greatly reduced.
If a polishing agent has been applied,
Please remove carefully with parts cleaner or alcohol tissue before pasting.
After peeling off the separator (mounting paper), paste it while being careful not to touch the adhesive surface.
Apply pressure to the entire surface and press it tightly.
It takes up to 24 hours for the initial adhesive strength of the adhesive to stabilize.
Please avoid moving or reapplying.
If the temperature is below 10 degrees, it will be difficult to paste, so please use a hair dryer etc.
Please warm it up a little before pasting it.
Flat/gentle quadratic curved surfaces made of common plastics (PE, PP materials)
This product is intended to be attached to interior panels.
For application to rough surfaces such as grained surfaces, curved surfaces, and soft-touch coatings.
Please use the included double-sided tape (JIS "super strong" manufactured by 3M).
Dome part: Polyurethane resin (non-yellowing)
Pattern notation: Hairline laser printing
Adhesive: Strong adhesive
Товар из Японии 
Возврат по недоставке
