@ROOMS AtTool Series Gate Finisher Starter Set, Glass File Shiner, 7-Step, for Gate Processing of Plastic Models and Gunpla

[All You Need! 3-Piece Basic File Set] This convenient model file set answers the needs of those who have trouble choosing from a wide range of files and want to achieve a higher level of finish with their tools. Suitable for beginners and advanced users alike, it beautifully finishes any surface. [Tempered Glass Gate Finisher] Made from high-quality tempered glass, it beautifully finishes the gate and surface treatments of plastic models and Gundam models. Its special ultra-fine particle processing ensures a smooth polish, achieving a higher level of finish. ● High polishing power allows for efficient processing in a short amount of time. ● The file surface is resistant to wear, allowing for semi-permanent reuse. ● Washable with water for easy removal of shavings, keeping the file clean! ● Rust-free, allowing for wet sanding without worrying about clogging. ● Storage case included. [Finishing Shiner] The abrasive has different roughness on the front and back, allowing for different surface finishes. After using the gate finisher to remove gate marks, you can polish them with the green side (1000 grit) for a smooth finish. If you're looking for a matte finish, the process is complete at this point. Further sanding with the white side (4000 grit) will achieve a smooth, mirror-like finish. ● The sponge is moderately flexible, making it suitable for curved parts. ● The sturdy 8mm thickness distributes pressure evenly for a smooth finish. ● It provides a firm grip and is easy to hold, making polishing a breeze. ● It can also be used to remove coarse sanding marks, remove sink marks, prepare a surface before painting, or polish after clear coat (to remove unevenness). ● Also recommended for clear parts where cut edges are easily visible! [7-Step Sander] Each of the four sides features seven different abrasive grits, allowing for different textures. Steps 1 through 7 increase in grit, making sanding easy even for beginners. Normally, start with STEP 3 and work your way through STEP 7 to achieve a finish similar to that of a standard kit. For deep sanding, such as with putty, start with STEP 1. ● This sponge is moderately flexible and can handle curved parts. ● Its 2.1cm and 1.7cm thicknesses distribute pressure evenly for a smooth finish. ● It provides a firm grip and is easy to hold, making polishing a breeze. ● It can easily remove sink marks on large surfaces. This three-piece set includes a tempered glass gate finisher, a finishing shiner, and a four-sided file. Procedure: 1. Prepare the gate with the gate finisher. This process will produce a clean finish, but some sanding marks may remain. 2. Lightly sand with the green side of the shiner. For a matte finish, this step is complete. 3. Sand with the white side of the shiner for a smooth, mirror-like finish. By completing this process, you can remove gate marks cleanly without painting. 4. The 7-step file is used to remove shrinkage on large surfaces. Usually, sanding starting from STEP 3 will produce a clean finish. 5. For an even cleaner finish, we recommend using a 4-sided file and a shiner together. ● Recommended for beginners to plastic models who are not used to assembling. ● Recommended for those who want to improve the finish of their unassembled models! ● Recommended for advanced users who want to use their techniques to achieve a higher quality finish. ● Recommended for those who are short on time and want to assemble efficiently. ● Recommended for those who do not have a good work environment and are unable to paint.