RXL SL Mtb Handlebar Carbon Handlebar Flat Bar Bicycle 560mm Cross Bike Handlebar 3K Matte Finish Mountain Bike Handlebar 25.4

1. Carbon Handlebar MTB Diameter: 25.4mm; Rod End Diameter: 22.2mm; Appearance: 3K Glossy/3K Matte; Size: 440/460/480/500/520/540/560/580/600/620/640/660/680/700mm; Riser Backsweep: 8°; Riser Upsweep: 3°; Riser Rise: 18mm; Flat Backsweep: 5°; Flat Upsweep: 0° 2.Made of carbon fiber, carbon fiber compared to aluminum alloy: Lighter weight. Much better looking. Brighter color. Excellent compressive strength. Impact resistance. Moderate elasticity, improves the class of your bike in minutes. 25.4mm carbon fiber handlebars are very light, stiff, and vibrate more pleasantly at speed than aluminum alloy bars. 3. Install the product correctly and follow the specified tightening torque (4Nm). It is recommended to use a hexagonal wrench to tighten the screws. Since it is made of carbon, it is recommended to tighten it by hand to support the body. Strong tension may cause cracks. 4. The torque value for carbon handlebars is 4Nm, the maximum torque is 5Nm. Just tighten the handlebars gradually, alternating. Tighten the flat handlebars until they can't move, then tighten them a little more. You can also apply the carbon fiber assembly paste to your MTB handlebars to ensure a tight fit with little risk of slipping. 5. Size Selection: Mountain handlebar width doesn't really correlate with wheel size, but depends on your riding style and the type of terrain you usually ride on. Bike feels like an enduro bike. Generally, cross-country riders prefer short handlebars, while enduro and downhill riders prefer very wide handlebars. Brand: RXL SL Material: Carbon fiber Color: Black/Grey Appearance: 3K Matte/3K Glossy Weight: Approx. 120g (680mm when laid flat) Handlebar diameter: 25.4mm Handlebar end diameter: Approx. 22.2mm Flat handlebar: 620/640/660/680mm Riser Handlebar: 640/660/680/700mm Riser back sweep: 8° Riser Upsweep: 3° Rise: 18mm Flat bar backsweep: 5° Flat Bar Upsweep: 0° Used: Mountain Bikes/MTB Bikes Features: Super lightweight, easy to install and remove. Installation Notes: 1. If you are installing carbon fiber MTB handlebars, please make sure the stem diameter is the same as your 25.4mm handlebars. 2. Observe the specified tightening torque (4 Nm). Maximum torque when clamping the rod: 5 Nm, torque for all screws is 3-5 Nm. 3. Please use a torque wrench for installation. Normal installation will cause a slight dent at the locking position. This is normal and does not affect the strength (excessive torque will cause damage and cannot be used normally. Normally it can be locked with 3.5Nm of anti-slip agent. Anti-slip agent role is not required. It can be firmly fixed) via lock) 4. Apply carbon fiber assembly paste to the 25.4mm rods to ensure a tight fit with little risk of slippage and tighten evenly in a crisscross pattern to 5Nm. Be careful not to overtighten the connectors.