Using way: Installation tool: tire puller tire loader screwdriver nut sleeve
1.mm hand drill (using a hand drill before drilling a large screw) Faucet
assembly: The first step: remove the front and rear guides and rear brakes of
the original car Step 2: Unpack the faucet kit 1. Locate the faucet and compare
the screw holes to the corresponding holes. 2. Screws pass from bottom to top
through the chassis and faucet 3. Plus nut fixing 4. Add the order on both
sides, so that the gasket (protrusion head upwards) - bearing shaft - guide
wheel copper tube - double guide wheel - bearing shaft - gasket (protrusion
head down) - 6mm aluminum tube - wave head, Install in order, the same on the
other side Middle wing installation: The first step is to open the middle wing
bag, pass the screw through the corresponding hole in the middle wing, fix it
with a nut, then put it into the big nail, add the wave head. In the second
step, the middle wing is fixed to the chassis, and the middle wing is mounted
on the chassis from the bottom, and the small screws of the middle wing bag are
taken out, and the middle wing is fixed to fix the chassis. The third step,
after fixing the screw, the upper nut forPhoenix tail installation: 1. Remove
the rear guide wheel and the bearing shaft, and use the tire puller to drive
the bearing shaft into the guide wheel, from bottom to top: gasket, gasket,
aluminum tube nut, aluminum tube, gasket, gasket, wave head 2, the order of the
fittings of thephoenix tail is: screw-shield (protrusion head up)-guide
wheel-shield (protrusion head up)-12mm aluminum tube-phob tail-nut-12mm
aluminum tube 0 gasket- Guide wheel - gasket, wave head 3, take out thephoenix
bracket and the ice cream bar, and fix it with the shortest screw and the
corresponding hole on the nut. 4, take out two 30mm screws through the ice
cream bar, use the nut to set, then add the shockabsorber, and finally add the
wave head 5. After thephoenix frame and the ice cream bar are fixed, remove the
screws to fix the bracket and the low plate. 6. Remove thephoenix tail with the
guide wheel installed and fix it from bottom to top with screws. Package
included: 1x Tamiya mini rc car parts (without wheel tire)
