Feature:
1. Equipped with two remote controls, the remote control distance is about 3-4 meters, and the use method is simple.
2. The maximum detection distance is about 3-5m, the detection range angle is 110 degrees, the performance is stable, safe and reliable.
3. The response is sensitive and rapid, and the alarm sound is up to 105 decibels, making it impossible for thieves to approach.
4. With the infrared warning device, you can open the window to sleep as long as it is hung on the wall opposite the window to monitor the window.
5. When the thief appears 1 meter outside your window, the alarm will automatically detect the alarm.
6. When the alarm is installed on the balcony, all the window on the balcony can be monitored at the same time, with good anti-theft performance.
Specification:
Condition: 100percent Brand New
Item Type: Door Alarm
Material: Plastic, electronic components
Battery:
Alarm: 4 x AA Battery (Battery Not Included)
Remote Control: 3 x LR44 Button Battery
Alarm sound: 105DB
Remote Control Distance: 3-4 m / 9.8-13.1ft at most (Remote control of partition wall and partition is not allowed, all remote controls of this type of anti-theft device are universal)
Detection Distance: The farthest distance is about 3-5 m / 9.8-16.4ft (room temperature is below 30 celsius ), which can"t be detected by partition or partition. When the temperature is higher than 30 celsius in summer, the detection distance will be shortened, which is not a quality problem.
Detection Range: Angle 110 degrees (detection distance and angle may vary slightly depending on the environment)
Weight: Approx. 200g / 7.1oz
Size:
Alarm Light: Approx. 12.2x9cm / 4.8x3.5in
Remote Control: Approx. 6x3.5cm / 2.4x1.4in
Usage Method:
1. Install the battery, turn on the alarm host with the remote control, and the green light will be on for about 20 seconds, which is the power on delay time. You can leave the detection area of the infrared alarm within 20 seconds.
2. After 20 seconds, the power on delay time is over, the green light is off, and the infrared alarm enters the warning state.
3. If someone enters the detection area of the infrared alarm at this time, the red light on the left of the green light will start to flash for 5 seconds. This 5 second delay is for the convenience of the owner to turn off the alarm in time to avoid unnecessary alarm sound.
4. After 5 seconds, if the host does not receive the signal to turn off the alarm, even if the uninvited guest has left the detection range, the alarm host will still emit a harsh alarm sound for 30 seconds, and the alarm volume is 105 decibels. 5 seconds after the end of the alarm sound, if there is another person walking in the detection range, it will alarm again and again.
5. When the infrared alarm sounds, you can turn off the alarm switch with the remote control to end the alarm.
Installation Method:
1. Fix the universal joint at a place about 2m away from the ground.
2. Open the battery cover and install 4 batteries (No. 5) according to the identification inside the battery box.
3. Fix the remote infrared warning device on the universal base, and turn the infrared warning device to meet the installation requirements and detection needs.
Package List:
1 x Alarm Light (Battery Not Included)2 x Remote Control1 x Universal Base
Note:
1. The probe shall not be directly to the outside, so as to avoid false alarm caused by idle people moving around.2. The probe shall be far away from cold and heat sources, such as air conditioner outlet, heating, air conditioner, etc.3. Avoid direct sunlight and automobile light when installing and using the probe4. It should be installed on the wall corner or wall. It is suggested that the installation height should be 2-3m away from the ground, with better effect.5. When the power on indicator is dark, the alarm sound is small and the false alarm rate of the infrared warning device is high, the battery voltage is generally insufficient, and the battery should be replaced in time.
