Feature:
1. Small in size and light in weight, easy to carry and assemble, 8 directions and easy to operate.
2. It is made of polycarbonate housing, which has high mechanical strength, high hardness, corrosion resistance and rust resistance.
3. Anti?exposure, high impact strength, long service life, suitable long?term use in outdoor environments.
4. With the internal smooth bearing system, the accuracy of information collection is effectively ensured and the use is more convenient.
5. High?performance bearings, low rotational resistance, accurate measurement, anti?electromagnetic interference treatment, can be applied to both four?wire and three?wire connection.
Specification:
Condition: 100percent Brand New
Item Type: Wind Direction Sensor
Material: Polycarbonate
Wide Voltage: 10-30V DC Power Input
Application: Widely used in the measurement of wind direction in greenhouses, environmental protection, weather stations, ships, wharf, breeding and other environments.
v\:* {behavior:url(#default#VML);}
o\:* {behavior:url(#default#VML);}
x\:* {behavior:url(#default#VML);}
.shape {behavior:url(#default#VML);}
Parameter:
DC Power Supply (Default)
10-30V DC
Maximum Power Consumption
Voltage Output
1.2W
Transmitter Circuit Operating Temperature
-20 celsius to +60 celsius , 0percent RH-80percent RH
Dynamic Response Time
less than 0.5s
Output Signal
Voltage Output
0-5V
Load Capacity
Voltage Output
Output Resistance less than 600 Ohm
Calculation Method:
0-5V Output Comparison Table
Output Value (V)
Corresponding Wind Direction
Approximately equal to0
North Wind
Approximately equal to0.7143
Northeast Wind
Approximately equal to1.4286
East Wind
Approximately equal to2.1429
Southeast Wind
Approximately equal to2.8571
South Wind
Approximately equal to3.5714
Southwest Wind
Approximately equal to4.2857
West Wind
Approximately equal to5
Northwest Wind
Product Size: Approx. 23.5 x 18.5 cm / 9.3 x 7.3 in
Weight: Approx. 315g / 11.1oz
Common Problems and Solutions:
No output or output error possible causes:
1) The range corresponding error causes the error PLC calculation. Please refer to the technical indicators for the range.
2) The wiring method is incorrect or the wiring sequence is wrong.
3) The power supply voltage is incorrect (24V power supply for 0-10V type).
4) The distance between the transmitter and the collector is too long, causing signal disturbance.
5) The PLC collection port is damaged.
6) Equipment damage.
Package List:
1 x Wind Direction Sensor1 x Cable1 x Screw Kit (4 x Screw, 4 x Nut)
Note:
1. The user should not disassemble it by himself, and should not touch the sensor core to avoid damage to the product.2. Keep away from high-power interference equipment as much as possible to avoid inaccurate measurement, such as inverters, motors, etc. When installing or disassembling the transmitter, the power must be disconnected firstly, and water in the transmitter can cause irreversible changes.3. Prevent chemical agents, oil, dust, etc. from directly invading the sensor, do not use it for a long time under condensation and extreme temperature environment, and prevent cold and heat shock.
