Camshaft Cam Shaft Seal Cover Cap Plug Triple O-Ring Aluminum Front Replacement For Honda Acura B D H F Series Engine Motor D15 D16

Application: For Acura Models: • For 97-03 Acura CL. • For 06-11 Acura CSX. • For 13-14 Acura ILX. • For 86-01 Acura Integra. • For 86-95 Acura Legend. • For 01-10 Acura MDX. • For 91-05 Acura NSX. • For 07-10 Acura RDX. • For 96-12 Acura RL. • For 14-15 Acura RLX. • For 02-06 Acura RSX. • For 95-14 Acura TL. • For 04-14 Acura TSX.

For Honda Models: • For 85-14 Honda Accord. • For 84-14 Honda Civic. • For 93-97 Honda Civic del Sol. • For 97-14 Honda CR-V. • For 11-14 Honda CR-Z. • For 88-91 Honda CRX. • For 03-11 Honda Element. • For 06-14 Honda Fit. • For 95-14 Honda Odyssey. • For 03-10 Honda Pilot. • For 79-01 Honda Prelude. • For 06-10 Honda Ridgeline. • For 00-09 Honda S2000. !!! For Acura & Honda B / D / H / F Series Engines Only!!! !!! For Engine Motor D15 D16 D17 B16 B17 B18 B20 H22 H23 F20 F22 K20 K24!!! Vehicle compatibility charts are for REFERENCE ONLY. Check product type and size to match your needs. Specification: • 100% quality assurance tested, more responsive, less expensive, easier to install. • Aftermarket replacement , precise fit. • Triple O-Ring for a positive sealing. • Direct bolt-on, no modifications required. • Recommended when servicing, removing or replacing camshafts. Material & Color: • Material: made of high quality Aluminum & Rubber. • Color: as picture. Package Included: • 1x Cam Seal Cap w/ 3 Rubber O-rings. (100% Brand New Never Used Or Installed) Installation Steps: • 1. Remove valve cover bolts. (10mm bolts) • 2. Remove 4 plug wires. • 3. Remove valve cover. • 4. Remove cam cap rail. (12mm, 10mm bolts) • 5. Remove camshaft endcap. (10mm bolts) • 6. Remove old cam seal. Clean area of old oil. • 7. Use RTV on the bottom of new cam seal. Place cam seal into position. • 8. Place cam endcap into position. Tighten 10mm bolts down. • 9. Place cam cap rail on. • 10. Run the bolts of rail down but do not tighten. (12mm, 10mm bolts) • 11. Use torque wrench to tighten 12mm bolts 20FT-lbs, 10mm bolts 7FT-lbs. • 12. Install valve cover. • 13. Install grommets, washers and bolts. • 14. Install plug wires. • 15. Install plug wire cover and you're done.